Vanquish PrePost
Product Type: OTC ANIMAL DRUG LABEL
Autor Name: DeLaval Inc.
Code Source: 55756-012
Route of Administration: TOPICAL
ACTIVE INGREDIENTS: Total Acid Mixture (lactic and phosphoric acids)..... 3%
Emollient............................................................. 15%
KEEP OUT OF REACH OF CHILDREN CAUTION MANTENER FUERA DEL ALCANCE DE LOS NINOS CUIDADO SI USTED NO PUEDE LEER ESTA ETIQUETA, POR FAVOR PIDA A ALGUIEN MAS QUE SE LA LEA ANTES DE USAR ESTE PRODUCTO READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
Not For Human Use Additional Information on Material Safety Data Sheet
STORAGE AND DISPOSAL
Thoroughly rinse all measuring devices and store out of reach of children. Avoid contact with food or feed. Avoid storing near heat or open flame. Keep container tightly closed when not in use. If product has frozen, thaw in a warm room and shake well before use. Do not reuse empty container. Rinse empty container before disposing of in a safe manner. Do not store in direct sunlight.
FIRST AID Contact with product can cause irritation to eyes and skin. Avoid contact with eyes and skin.
If On Skin: Flush affected area with water. Remove contaminated clothing and shoes. Get medical attention if irritation develops.
Eye Contact: Flush with water. Remove contact lenses, if present, after first 5 minutes. Then continue rinsing. Get immediate medical attention.
If Swallowed: Do not induce vomiting. If victim is fully conscious, give a cupful of water. Never give anything by mouth to an unconscious person. Get immediate medical attention.
CHEMTREC EMERGENCY NUMBER 1-800-424-9300
USE DIRECTIONS MIXING INSTRUCTIONS
Using a manual pump or automatic system, mix 1 part of Vanquish ™ Pre Post BASE and 1 part of Vanquish ™ Pre Post ACTIVATOR into a clean teat cup or container at least 30 minutes prior to use. Mix product until color is uniform. Prepare only the quantity needed for one milking. GENERAL INSTRUCTIONS
Use mixed solution at full strength (do not dilute). Do not use base or activator alone on cow teats. Consult your veterinarian before using a teat dip on a cow with sore or chapped teats. Use fresh teat dip for each milking. Dip solution should be changed if it becomes visibly dirty, or if sediment is introduced. Do not pour used teat dip back into original container. Do not use for cleaning or sanitizing equipment. To discard unused teat dip, dilute with water and pour down the drain. PRE-DIPPING
Remove excess soil and forestrip. (If water is used, use a minimal amount and dry thoroughly with a clean, single-service paper towel before forestripping). Dip teats with mixed Vanquish ™ Pre Post teat dip to base of udder. Allow a 15 to 30 second contact time. Dry teats thoroughly with a clean, single service paper towel. Attach milking unit. POST-DIPPING
Immediately after removing milking unit, dip or spray teats with Vanquish ™ Pre Post teat dip. Do not wipe. If outside temperature is below freezing, allow Vanquish • ™ Pre Post teat dip to air-dry on cow `s teats before cow is released outside; or allow teat dip to remain on teats for one minute, then dry teats with a single-service paper towel. Failure to follow these directions may result in frozen teats and injured animals.
Manufactured for:
DeLaval
Kansas City, MO 64153
Copyright 2007, DeLaval
Made in U.S.A.
Sanitizing Pre and Post Teat Dip Disinfectante pre y post ordeno
ACTIVATOR - For use with only Vanquish ™ Pre Post BASE
Image of Container Label
Autor Name: DeLaval Inc.
Code Source: 55756-012
Route of Administration: TOPICAL
Vanquish Pre-Post
Generic: Lactic Acid, Phosphoric AcidIngredients:
- Lactic Acid Lactic Acid : Active ingredient - basis of strength - 12.6 g in 1 L
- Phosphoric Acid Phosphoric Acid : Active ingredient - basis of strength - 58.7 g in 1 L
Package Description:
- 18.9 L in 1 PAIL
- 56.8 L in 1 DRUM
- 208.2 L in 1 DRUM
- 1040.9 L in 1 DRUM
ACTIVE INGREDIENTS: Total Acid Mixture (lactic and phosphoric acids)..... 3%
Emollient............................................................. 15%
KEEP OUT OF REACH OF CHILDREN CAUTION MANTENER FUERA DEL ALCANCE DE LOS NINOS CUIDADO SI USTED NO PUEDE LEER ESTA ETIQUETA, POR FAVOR PIDA A ALGUIEN MAS QUE SE LA LEA ANTES DE USAR ESTE PRODUCTO READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
Not For Human Use Additional Information on Material Safety Data Sheet
STORAGE AND DISPOSAL
Thoroughly rinse all measuring devices and store out of reach of children. Avoid contact with food or feed. Avoid storing near heat or open flame. Keep container tightly closed when not in use. If product has frozen, thaw in a warm room and shake well before use. Do not reuse empty container. Rinse empty container before disposing of in a safe manner. Do not store in direct sunlight.
FIRST AID Contact with product can cause irritation to eyes and skin. Avoid contact with eyes and skin.
If On Skin: Flush affected area with water. Remove contaminated clothing and shoes. Get medical attention if irritation develops.
Eye Contact: Flush with water. Remove contact lenses, if present, after first 5 minutes. Then continue rinsing. Get immediate medical attention.
If Swallowed: Do not induce vomiting. If victim is fully conscious, give a cupful of water. Never give anything by mouth to an unconscious person. Get immediate medical attention.
CHEMTREC EMERGENCY NUMBER 1-800-424-9300
USE DIRECTIONS MIXING INSTRUCTIONS
Using a manual pump or automatic system, mix 1 part of Vanquish ™ Pre Post BASE and 1 part of Vanquish ™ Pre Post ACTIVATOR into a clean teat cup or container at least 30 minutes prior to use. Mix product until color is uniform. Prepare only the quantity needed for one milking. GENERAL INSTRUCTIONS
Use mixed solution at full strength (do not dilute). Do not use base or activator alone on cow teats. Consult your veterinarian before using a teat dip on a cow with sore or chapped teats. Use fresh teat dip for each milking. Dip solution should be changed if it becomes visibly dirty, or if sediment is introduced. Do not pour used teat dip back into original container. Do not use for cleaning or sanitizing equipment. To discard unused teat dip, dilute with water and pour down the drain. PRE-DIPPING
Remove excess soil and forestrip. (If water is used, use a minimal amount and dry thoroughly with a clean, single-service paper towel before forestripping). Dip teats with mixed Vanquish ™ Pre Post teat dip to base of udder. Allow a 15 to 30 second contact time. Dry teats thoroughly with a clean, single service paper towel. Attach milking unit. POST-DIPPING
Immediately after removing milking unit, dip or spray teats with Vanquish ™ Pre Post teat dip. Do not wipe. If outside temperature is below freezing, allow Vanquish • ™ Pre Post teat dip to air-dry on cow `s teats before cow is released outside; or allow teat dip to remain on teats for one minute, then dry teats with a single-service paper towel. Failure to follow these directions may result in frozen teats and injured animals.
Manufactured for:
DeLaval
Kansas City, MO 64153
Copyright 2007, DeLaval
Made in U.S.A.
Sanitizing Pre and Post Teat Dip Disinfectante pre y post ordeno
ACTIVATOR - For use with only Vanquish ™ Pre Post BASE
Image of Container Label